OZARK MOUNTAIN CEDAR PRODUCTS
Modular Gazebo Kit Assembly
VII. Assemble Benches
ASSEMBLY NOTES:
This section will be the last assembly procedure, which covers the assembly of the benches. There are a total of four benches to assemble. The benches are not secured to the Gazebo to allow the interior to be easily rearranged.
| Step 1: Apply adequate amount of construction adhesive to areas where bench legs will be located. |  |
| Step 2: The beveled ends of bench legs were designed to be at the base of the bench. Position the best visible surface to face the front of the bench. Insert the square cut end of the leg to rest on the underside of the bench seat and to mate with the facial board of bench seat.
Step 3: Drill two 5/32” holes, offset from each other, through bench facial board and into each one of the four legs |
 |
| Step 4: Drive two 3” screws through each drilled hole to secure the bench leg to the bench seat. |  |
| Step 5: Repeat this procedure for the remaining 3 benches. Place the four benches in the Gazebo in your desired location. |  |
